Accessories CHEAP!! Low Boy / Lightweight Aluminum Floor Jack...

[kendog]

CHEAP!! Low Boy / Lightweight Aluminum Floor Jack...

I've seen the one on ECS before, but at ~$300!! plus shipping, (at $254 to Sydney, totaling a whopping $554!!) that's too expensive ..
Volkswagen Golf IV 1.8T > Tools > Wheel Tire > ES#240941 Low Boy / Lightweight Aluminum Floor Jack - PJM-626


INSTEAD, I've spotted this one sold by DIY tools in Australia, going for $150!! AND the design looks exactly the same!! ...
1.5 Ton Aluminum Racing Jack Blue in Colour (T815012L)

[bennjamin]

you can also get the same jack from COSTCO amongst other places - all based upon the same design minus a few differences.
Its $169 @ costco. Decent jack

[kendog]

CHEAP!! Low Boy / Lightweight Aluminum Floor Jack...

Nice one!

[mitch750]

ive got 2 of the second one you posted and they work well for me i even use them to lift my car up in the driveway, which has a slight slope and also has ridges in it.... but cant fault them

[kendog]

CHEAP!! Low Boy / Lightweight Aluminum Floor Jack...

Thanks dude! Great feedback! I think I'll get one soon..

[PranK]

Yeah I'll get one too. Although, my tough old ol' skool 2 tonner does such a good job, even on my sloped drive.

[hamza]

Be careful, that jack is only capable of lifting 850k.. Not 1.5T as they claim.

[Transporter]

Though it has the lifting capacity only 850kg, somehow they confused the units, 1500lb is not 1.5Ton.

I've picked up a nice 2Ton similar jack from TTI at Lonsdale for $199 , it has a quick lift double pump and 450mm raised height.

[Umai Naa!!]

Yeah, definately not 1.5T.

A mate has one, and struggles to lift anything bigger than a Commodore, as you can imagine.

I've got an Arcan 1.5T, same as Costco. It's got two front wheels on the outside of the chassis, instead of the single roller. Much better for stability, if the ground's not that great. It's not that light, but not too heavy for constantly lifting it in and out of the van. Only other gripe, is that it's an inch too high to go under the front of GTIs, R32s, etc.

[kendog]

yeah, main reason for looking at one of these, is to get under my 'GTI' lowered on coils.

So, will the ~850kg jack lift the front of the car on its own? (to get stands under there?) or would I still have to lift one side at a time?? (PITA)

[kendog]

reviving this old thread again, I now have time off and am looking to buy one to do some repairs etc.

So, I'm looking for one that is 1.5T, can go lower than 100mm, and is around $200. Anyone got any leads?