QLD WTD-24V vr6 bracket for alternator + all on it.

[Zombie76]

I'm chasing the bracket that attaches the alternator, psteer pump, A/C pump and idlers/tensioners to the
24V vr6 found in the Mk4 r32 and or 2.8 24 VR6 boras here.

Reason.... I'm fitting a later vr6 motor 2008 r32 into a older car that requires the use of power-steering pump

Your help IS really appreciated

Hamish
0400792026
QLD

[Golf Loon]

Can't help with the part but I needed one once for a conversion and it was less than $200 for a new one from vw.

[Zombie76]

Ok
I'm unfamiliar with these models.
Can you tell me the exact years/ models and or engine codes?

What about the various components that bolt to the bracket .... Do I need to be getting the alternator, power steering pumps ac comp for the same era?

Is there seperate tensioners needed also?

I'd like to understand what it the total package required and from what to allow me to source and the just install & work.

[HaydEn]

WTD-24V vr6 bracket for alternator + all on it.

Depending on what chassis you are putting this engine in there may be changes.

But in a mk3, you can use the 4mo alternator bracket (2. and vr6 mk3 ancillaries bolt on to it.

[Zombie76]

I'm putting it into a strange chassis......
A 1991 Vw Kombi van!
So I'm just trying to figure out what I can get that bolts up neatly and functions as intended underneath the mk5 intake manifold,
I do wish to keep ground clearance to a maximum.
Thanks for the reply!!!