Tweet
I have 20 brackets to sell first . these will allow you to mount the golf pop out badge RVC into your 6R Polo.
As these where the first batch and i didnt want to go to stupid to begin with i only got a small amount done. i planed to do more but i have had to go away for work so am unable to do more untill i return so some will need to be patient
install instructions can be found here
Details:
its been laser cut from 1.6mm galvinised steal. I had intended to have them powder coated but the cost per unit would have been to much. So you can do it your self or a coat of galv primer will do the job as the edges may get some surface rust as they are unprotected due to the cutting process. I have gone to every effort to make sure it will fit straight up with a little adjust ment to centre the badge, but as i have found the mounts can be a little different from car to car so if you cant get it centered then just drill the three screw holes out to the next size up for a little bit more movement. This will not affect the bracket clamping. If you tighten the screws evenly the badge will self centre pretty well and only need a tiny adjustment. do not tighten them to much as you will distort the bracket.
How to get one:
For Aus customers $40 posted express. UK Posted is $65 and will take two weeks (express is $60 alone not including bracket so makes it pointless) will have to get a quote for anyone else.
Do not post your interest on this thread. first 20 to PM will get them. If i reply with payment details then youve been one of the lucky
first 20. for those that miss out i will be returning home in november and if there is enought interest i will get more cut.
As these where the first batch and i didnt want to go to stupid to begin with i only got a small amount done. i planed to do more but i have had to go away for work so am unable to do more untill i return so some will need to be patient
install instructions can be found here
Details:
its been laser cut from 1.6mm galvinised steal. I had intended to have them powder coated but the cost per unit would have been to much. So you can do it your self or a coat of galv primer will do the job as the edges may get some surface rust as they are unprotected due to the cutting process. I have gone to every effort to make sure it will fit straight up with a little adjust ment to centre the badge, but as i have found the mounts can be a little different from car to car so if you cant get it centered then just drill the three screw holes out to the next size up for a little bit more movement. This will not affect the bracket clamping. If you tighten the screws evenly the badge will self centre pretty well and only need a tiny adjustment. do not tighten them to much as you will distort the bracket.
How to get one:
For Aus customers $40 posted express. UK Posted is $65 and will take two weeks (express is $60 alone not including bracket so makes it pointless) will have to get a quote for anyone else.
Do not post your interest on this thread. first 20 to PM will get them. If i reply with payment details then youve been one of the lucky
first 20. for those that miss out i will be returning home in november and if there is enought interest i will get more cut.
Comment