Tweet
VW 16V 28% underdrive billet custom pulley for Mk2 (KR) 16V, may suit others. This reduces the parasitic power loss from driving the alternator and water pulley freeing more power to the wheels. Pulley is new and machined from lightweight billet. Comes with all mounting bolts and weighs a tiny 431g. $120 and it's yours
Brand new lightweight aluminium valve retainers(x17) to suit VW AUDI 16V Aluminium valve retainers 9A KR ABF ACE 6A with 7mm valve stems. I went with titanium so these have become surplus to my needs. Retainers weigh on average 6.5 grams against the std of almost 20 grams. I deal for motors running high revs and big cams but also can be run with stock gear and will increase performance through less moving mass. with these you can use with original valve collets. These are yours for well under cost at $135.
For the guys running really really low,2x bump steer kits to flip the steering arms which brings them back to a more level position (fitted the third of these to my rally car and it is much better and these were going in spare hubs but now surplus to my needs). Simple to fit, you just need to either yourself or get a mchine shop to do it for you (like $50) to drill out the old spindle in the hub with a 17mm hole and press these in. All can be done within 30min to get the steering response back and make your lowered car much much safer.Yours for $25
Brand new lightweight aluminium valve retainers(x17) to suit VW AUDI 16V Aluminium valve retainers 9A KR ABF ACE 6A with 7mm valve stems. I went with titanium so these have become surplus to my needs. Retainers weigh on average 6.5 grams against the std of almost 20 grams. I deal for motors running high revs and big cams but also can be run with stock gear and will increase performance through less moving mass. with these you can use with original valve collets. These are yours for well under cost at $135.
For the guys running really really low,2x bump steer kits to flip the steering arms which brings them back to a more level position (fitted the third of these to my rally car and it is much better and these were going in spare hubs but now surplus to my needs). Simple to fit, you just need to either yourself or get a mchine shop to do it for you (like $50) to drill out the old spindle in the hub with a 17mm hole and press these in. All can be done within 30min to get the steering response back and make your lowered car much much safer.Yours for $25
Comment