QLD Greg's ( Cogdoc's ) garage cleanout!

[Greg Roles]

Here's a list of extra bits I have found around the workshop and don't need. Prices pickup in and around Brisbane, postage is extra.

1. Swoosh EGT guage White and blue on black, red needle, startup and shudown show, stepper motor, in Good condition. Is in deg F as it's American. Lens is slightly marred, but no actual scratches, just dulled slightly from being cleaned. No longer needed as my Snow kit displays EGT's. HIGHLY RECOMMENDED for any diesel!!! Cost toward $100 posted, sell for $40. Pending SOLD.

[Greg Roles]

Gauge pending sold...

[Greg Roles]

Nascar style blower for brakes, engine bay, over turbo, intercoolers etc. 6 amp 3" inlet and outlet, very high flow. I bought two, only need one. $30 plus post on e-bay, sell for $20. Brand new, just dusty!

[Greg Roles]

VDO piggyback M10x1 oil temp / pressure etc adaptor T piece bought from 42 Draft designs. I used one to put my oil pressure sender inline with the stock oil temp fitting, no leaks! Sell for $10.

[Greg Roles]

MK V Taillight tint kits. Also includes 1 x headlight, if you read my threads you can see where I tried, and failed to apply to the very curved front lights. Comes with the oher stuffed headlight one, ut take this as a rear set with one extra headlight set to use for small bits etc. The 4th one I tried is pretty much stuffed. Decent thick film, bought from the USA. Sell for $10.

[Greg Roles]

SVT lightening 12V intercooler water pump, genuine Bosch product, might suit a small capacity engine waterpump, but specifically designed for water to air intercoolers. High flow 317 gallons per hour, runs at 0.3 bar, serious motor. 19mm 3/4" inlet and outlet. Cost $100 plus ship, sell for $40.

[Greg Roles]

2.5" intercooler pipe and fittings as pictured. Alloy pipe, basic chinese kit, but certainly does the job. Recommend getting the ends rolled at an exhaust shop for higher PSI and diesel applications, or better yet Tig weld it up as much as possible. Left over from the three kits I bought to do my car up. One pipe has a ding in the end as pictured, but easy to bend back out. All as new, hardly a scratch. Rubber bits all suit 2.5".

$50 the lot! Pending SOLD.

[Greg Roles]

3" pipe fittings, elbows, joiners and 3" to 2.5" reducers. The straight connectors have clamp marks, but all still very usable. I used bits like these to make up my about to be fitted 3" airfliter to turbo inlet. The stock MAF housing is 3", so works a treat.

$25 the lot! Pending SOLD...

[dubsquad]

PM sent, check it!!!!!

[STOIE]

Lol I want backyard F/I with that blower! haha