If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed, registering will remove the in post advertisements. To start viewing messages,
select the forum that you want to visit from the selection below.
This means you should apply for your renewal now to avoid any disruptions to your membership whilst the renewal process is taking place! NOTE: If you have an auto renewing subscription this will happen automatically.
you need a new hw revision for dab. i installed one sourced from europe into my b7 passat, we simply ran the fakra cable down to the b pillar connected to a bit of stripped cat6 cable. i do have the factory antenna splitter for the antenna however i am yet to install, it performs with my macgyver antenna very well.
I have rns-510 p version. I wonder what would be need to activate dab or dab+?
I am little bit confused...some people says that i need dab adaptor, some say that not gonna work in australia....
I read that only these units have the following part number are DAB+ specific.
1t0035686c or d. c for inbuilt with western maps or a d on the end for eastern maps. As you have pointed out in the above photo it's got to have an antenna connector at the top of the unit. RNS510's of today don't have that extra.
Leave a comment: